Device config deployment to replacement hardware

MIBS, SMMPv1, SMMPv2, SMMPv3 and management
Guest

Re:Device config deployment to replacement hardware

Post by Guest » Thu Mar 01, 2007 5:08 pm


Config engine is now just a software solution which can run on Solaris or Linux.

Romain
Hello I'm new here
Posts: 1
Joined: Tue Jun 12, 2012 8:18 am
Location: France

Re: Re:Device config deployment to replacement hardware

Post by Romain » Tue Jun 12, 2012 8:45 am

Hi all,

As the first guy, I'm doing a process to setup a replacement unit when a switch fails. I want to deploy an existing configuration in LMS on a new hardware. The spare device is already pre-configured with an ip address but not the dead device's ip address (in another subnet), and reachable in LMS with a basis configuration. I would like to push the config before the device will physically moved to it's destination.

You mentionned "RME does not yet support a zero-touch deployment. This feature is being considered for the next release of LMS", does it work in LMS 3.2 ? Or could you please precise in which version does it work?

Thank your very much!
Romain

Post Reply