CCM server QoS

Post a reply

In an effort to prevent automatic submissions, we require that you complete the following challenge.
:D :) ;) :( :o :shock: :? 8-) :lol: :x :P :oops: :cry: :evil: :twisted: :roll: :!: :?: :idea: :arrow: :| :mrgreen: :geek: :ugeek:

BBCode is ON
[img] is ON
[flash] is OFF
[url] is ON
Smilies are ON

Topic review

Expand view Topic review: CCM server QoS

Re: CCM server QoS

by 3dwalkthrough01 » Thu Oct 23, 2014 6:07 am


Is CCM server capable of QoS marking signalization packets that sends ? ... ering.html

Re: Re:CCM server QoS

by susanjohnston79 » Wed Jun 29, 2011 4:55 am

This can be changed in the administration of CCM System Settings business. You can check to see if values ​​have changed. Also, make sure that these packages are not seen in any other part of the network.

Re:CCM server QoS

by Guest » Mon Dec 20, 2010 2:51 am

HiYes - as I mentioned before, your CCM port must be configured to trust DSCP 'qos trust dscp' not trust COS.COS is a marking in the dot1q or ISL header of a packet - as the CallManager is not on a trunked port like phones are, it can NOT mark COS on packets.Also you wouldn't normally have 'switchport voice vlan' on the port to CallManager as it is an access port in that VLAN.RegardsAaronPlease take the time to rate helpful posts...

Re:CCM server QoS

by Guest » Mon Dec 20, 2010 1:56 am

thanks for your answers.In Ent. Par. Conf. DSCP marking of packets is set, and this is QoS configuration of switch that CCM is attached to (WS-C4506):qos dblqos map dscp 24 25 26 27 28 29 30 31 to tx-queue 4qos map dscp 32 33 34 35 36 37 38 39 to tx-queue 4qos map cos 3 to dscp 26qos map cos 5 to dscp 46qosinterface GigabitEthernet6/45 switchport access vlan 10 switchport mode access switchport voice vlan 10 service-policy output autoqos-voip-policy qos trust cos auto qos voip trust tx-queue 3   priority high   shape percent 33Is there something that must be changed in cofiguration? thx

Re:CCM server QoS

by Guest » Mon Dec 20, 2010 12:48 am

HiAlso if you are sniffing at the downstream (phone) end it would be worth verifying that you have both enabled qos and set the port trust state on the port the CM is attached to to 'trust DSCP'.RegardsAaronPlease rate helpful posts...