No Pim Neighbor with MVPNs

Static, RIP, EIGRP, OSPF, BGP, IBGP, IS-IS and any other routing.
Guest

Re:No Pim Neighbor with MVPNs

Post by Guest » Fri Feb 25, 2005 12:47 am


Ok, I triple checked everything ;-) and I think I found why it's not working.You didn't configure route-reflector client in the MDT AF. You should have on the RR:address-family ipv4 mdt  neighbor 203.194.30.61 activate  neighbor 203.194.30.61 send-community both  neighbor 203.194.30.61 route-reflector-client  neighbor 203.194.30.63 activate  neighbor 203.194.30.63 send-community both  neighbor 203.194.30.63 route-reflector-client  exit-address-family!So the update received from PE2 will be propagated to PE1.Let me know if it's working after the change.ThanksLaurent.

Guest

Re:No Pim Neighbor with MVPNs

Post by Guest » Fri Feb 25, 2005 1:04 am


hang on mate just checking config now :o)

Guest

Re:No Pim Neighbor with MVPNs

Post by Guest » Fri Feb 25, 2005 2:38 am


I have added the config on the RR in teh MDT family and its still not working

Guest

Re:No Pim Neighbor with MVPNs

Post by Guest » Fri Feb 25, 2005 3:51 am


Please clear the session and check with the debugs if the RR is sending the update to PE1.Even after it's not working, last option I see before opening a TAC case is to try with SRC2 as it's the one I used in my set-up.Laurent.

Guest

Re:No Pim Neighbor with MVPNs

Post by Guest » Fri Feb 25, 2005 5:22 am


nope still have the same problemrouter bgp 20 bgp router-id 203.194.30.62 no bgp default ipv4-unicast bgp log-neighbor-changes neighbor 10.2.0.5 remote-as 10 neighbor 10.2.0.5 description ebgp to rrv01.syd01.test neighbor 10.2.0.5 ebgp-multihop 255 neighbor 203.194.30.61 remote-as 20 neighbor 203.194.30.61 description BDR02-SYD neighbor 203.194.30.61 update-source Loopback0 neighbor 203.194.30.63 remote-as 20 neighbor 203.194.30.63 description WSR17-SYD neighbor 203.194.30.63 update-source Loopback0 ! address-family ipv4  no synchronization  no auto-summary exit-address-family ! address-family vpnv4  neighbor 10.2.0.5 activate  neighbor 10.2.0.5 send-community both  neighbor 203.194.30.61 activate  neighbor 203.194.30.61 send-community both  neighbor 203.194.30.61 route-reflector-client  neighbor 203.194.30.63 activate  neighbor 203.194.30.63 send-community both  neighbor 203.194.30.63 route-reflector-client exit-address-family ! address-family ipv4 mdt  neighbor 203.194.30.61 activate  neighbor 203.194.30.61 send-community both  neighbor 203.194.30.61 route-reflector-client  neighbor 203.194.30.63 activate  neighbor 203.194.30.63 send-community both  neighbor 203.194.30.63 route-reflector-client exit-address-family

Post Reply