Flash Light on LightWeight AP?

Configuring Wireless Cisco Networks and Wireless Controllers.
Guest

Flash Light on LightWeight AP?

Post by Guest » Sat Sep 11, 2010 1:40 am


HelloIs there a way through the wireless contorller(5.2.178.0) to flash the light on a 1250 series lightweight AP that is managed by that controller?I have about 8 - 9 1250's that got deployed on a 30 foot high ceiling and didnt get their MACs documented or any identification put on them before they were installed.  Id like to be able to identify each one without having to take them down(they are in use) or dig up a 30 foot ladder.thankse-

Alt+MAlt+N
Guest

Re:Flash Light on LightWeight AP?

Post by Guest » Sat Sep 11, 2010 2:26 am


Hi Eric,Would turning the LED off one by one work?I'm not sure if this works for the 1250, but maybe you could give it a try; config ap led-state To enable or disable the LED-State for an access point, use the config ap led-state command. config ap led-state {enable | disable} {Cisco_AP | all} Syntax Description config Display configurations. ap Advanced parameters. led-state Enable or disable the LED-State for an access point. {enable | disable} Enable or disable the access point's LED-State. {Cisco_AP | all} Name of a Cisco 1000 Series lightweight access point or all to specify all access points. http://www.cisco.com/en/US/docs/wireles ... #wp2384867 Hope this helps! Rob

Guest

Re:Flash Light on LightWeight AP?

Post by Guest » Sat Sep 11, 2010 2:29 am


Tested and that will work perfectly.Thanks Robe-

Guest

Re:Flash Light on LightWeight AP?

Post by Guest » Sat Sep 11, 2010 3:08 am


Hi Eric,Great stuff! Thanks for letting us know this still works with the 1250 series.Cheers!Rob

Post Reply