Page 1 of 2

AIR-LAP1252AG-E-K9 blinking green red yellow

Posted: Mon Jan 01, 2007 8:23 am
by Guest

Hello,I have just started a new 1252 access point and I get the status blinking green red yellow + ethernet blinking green and radio blinking amber.The AP responds to ping but I cannot telnet it.I understoods that the blinking scheme if that the AP is not finding the controller as I do not have any.I bought this AP to work on standalone mode and it seems that its not loaded for that. When I try to download the IOS file to switch to standalone mode, I got an unauthorized error as I do not have a service contract.How should I proceed to use the AP in standalone mode ?ThanksStephane

Re:AIR-LAP1252AG-E-K9 blinking green red yellow

Posted: Mon Jan 01, 2007 9:25 am
by Guest

Re:AIR-LAP1252AG-E-K9 blinking green red yellow

Posted: Mon Jan 01, 2007 10:58 am
by Guest

Hi Stephane, You need to get hold of the autonomous IOS (aIOS) to be able to successfully convert your AP from LWAP to autonomous.Contact the authorized Cisco reseller if they can download the firmware for you.

Re:AIR-LAP1252AG-E-K9 blinking green red yellow

Posted: Mon Jan 01, 2007 12:08 pm
by Guest

Yes thank you. I did it this morning and receive the file from them. With the above procedure everything is fine now.Thanks a lot,Stephane

Re:AIR-LAP1252AG-E-K9 blinking green red yellow

Posted: Mon Jan 01, 2007 12:08 pm
by Guest

Hi Stephane, Thank you for the ratings.