exterlan LED satus 1131AG - turn it off
exterlan LED satus 1131AG - turn it off
hithis weeken i setup a wireless network in a large house and everything is working perfectly. the only complaint i received was that hte external led light is very bright when it gets dark (as it is located in one of the bedrooms this is a bit of an issue)i found the following command AP1(config)#led display ? dim Turn LED display dim. off Turn LED display off.AP1(config)#led display offi applied the above command but i have no way of veryfing (as i am not on site) if the external led has now turned off.i could not find a command to show me the current led status (on/off/dim)so 2 questions1) will this command have turned off the external LED2) how can you verify via the command line what the current status ismany thanks
Re:exterlan LED satus 1131AG - turn it off
Hi Rogier,Yes, this command should have fully darkened the LED Display;This example shows how to turn-off the 1130AG Status LED:AP(config)# led display offhttp://www.cisco.com/en/US/docs/wireless/acces ... 339779This should be seen in a "show run" for the APHope this helps!Rob
-
- Hello I'm new here
- Posts: 1
- Joined: Mon Sep 02, 2013 7:50 am
- Location: USA
Re: Re:exterlan LED satus 1131AG - turn it off
Ya it helps for sure.. I am facing similar issue but I tried your way out and it was sorted out.. ThanksGuest wrote:Hi Rogier,Yes, this command should have fully darkened the LED Display;This example shows how to turn-off the 1130AG Status led lights:AP(config)# led display off This should be seen in a "show run" for the APHope this helps!Rob